motorcycle lower section

Motorcycle Pre-Ride Inspection Checklist

Many people make the mistake of starting riding their motorcycles immediately without any inspection. In fact, it is crucial to inspect the condition of your bike before starting to ensure you will not face any issues on the road.

Experienced bikers are typically more aware of the things that they must inspect before riding the motorcycle. This process of inspecting your motorcycle is important for all types of motorcycles and for both experienced and beginner riders.

Following are the seven steps that you should follow to ensure your bike is in the best condition to ride:

1. Body

First of all, you should make sure the overall body of the motorcycle is intact and perfectly fitted. You should be looking for small cracks and chips in the frame, especially in joint welds and other motorcycle accessories. 

Make sure that the footpegs are firmly attached to the bike.


2. Tyres and Wheels

You should carefully inspect both of the tyres of the motorcycle before starting a ride. The purpose of this thorough inspection is to make sure there are no objects stuck in them, and they are in good health for a safe ride. You should also check the air pressure, especially in the cold season, and ensure you have enough air to complete the ride.

Otherwise, you can face difficulty in finding a tyre shop or motorcycle spare parts shop if your motorcycle starts malfunctioning during the ride. Most of the manufacturers have a recommended psi for various types of motorcycle, so you should make the pressure on the tyres is enough.


3. Hoses

Checking the hoses can be difficult in some motorcycles. However, you should try to make sure that the hoses that connect components like brake lines and radiator are properly connected.

Most of these hoses are made of rubber, so you should also be looking for cracks that can cause malfunctioning at a later stage.


4. Brakes

It should go without saying that brakes are one of the most important components of your motorcycle. You should fully check the brakes by examining the brake pads and identifying any potential tears in them.

If there is no groove on the brake pads, consider replacing them. Check both rear and front brakes to make sure they feel solid.


5. Electrical System

Inspecting the electrical system of your motorcycle can also be a challenging task for a beginner. However, you can easily do it by following the motorcycle’s guidebook, watching an online tutorial, or following these guidelines.

First of all, you should open up the battery compartment and examine the battery to see if you are able to detect any fault like corrosion. If you see a lot of accumulated dust and debris on the terminals, you should gently wipe them down with the help of a baking soda solution. Moreover, test the battery to ensure it is properly charged.

The next step in battery inspection is to turn the key in the ignition and ensure the console display and the entire electrical system is working as per the best condition. Focus on examining the brake lights, running lights, headlights, and turn signals

If any of the electrical components are malfunctioning, you should visit a motorcycle accessories shop to buy the right kind of equipment or aftermarket motorcycle parts.


6. Fluids

A motorcycle must have some essential fluids for its proper functioning. You can quickly check the fluids like engine oil, brake fluid, and transmission fluid. However, make sure that your motorcycle is cold while you are dealing with these fluids.


7. Handlebar Controls

It is easy to check the flexibility and efficiency of the handlebars. Simply rotate the handlebars and ensure they are rotating in full motion. Moreover, check the control of the handlebars like a clutch to ensure they are working with optimum performance. 

However, if the handlebars are not rotating with maximum motion, you might have to contact a repair shop. 


The Bottom Line

If you detect an issue in your motorcycle, there is a very high chance that you will be able to sort out the issue on your own by following the bike’s manual. For example, if the level of certain fluids is low, you can easily add it.

However, in some cases, you might have to get aftermarket motorcycle spare parts from a motorcycle accessories shop before you can repair it on your own. If you think that there is a severe issue with the bike, go for a professional, reliable, and experienced repair service.

Motorcycle Pre-Ride Inspection Checklist